Take the 2-minute tour ×
Seasoned Advice is a question and answer site for professional and amateur chefs. It's 100% free, no registration required.

I recently decided to smoke and entire chicken so I dropped it in and kept the smoker around 225-250 for about 4 hours. I went in and sprayed it down with a little apple juice and vegatable oil every hour or so. The meat came out delicious and tender, but the skin was so tough it was not edible.

What can I do differently to keep the skin from getting so tough?

share|improve this question

3 Answers 3

up vote 9 down vote accepted

Take cheesecloth and soak it in melted butter and drape it over the bird before you put it in the smoker. This will protect the skin during the long slow smoking process. You may want to pull the cheesecloth off about 30 minutes before you are done. This will give you a nice golden brown skin that is not leathery.

I first read of doing this with a smoked turkey, but tried it with a chicken and it comes out great.

share|improve this answer

225-250 is too low a temperature for chicken. Chicken doesn't benefit from "low and slow" cooking, because it doesn't contain connective tissue that needs to be broken down, and the skin needs a higher temperature to crisp.

Here is a page from Virtual Weber Bullet which talks about how to get a crisp skin while smoking. They recommend cooking at 300 degrees F.

share|improve this answer

First thing I would recommend is not spraying down the skin with the oil/apple juice mixture. There is plenty of fat in chicken skin. No need to add more. And spraying the skin will just keep it from rendering out the unwanted fat and other tissue, thus preventing it from crisping.

The other thing I would suggest is to turn the heat up on the chicken. Low heat + smoke = rubbery and tough skin. I do a lot of barbecue, and I never find any compelling reasons to do chicken low and slow, unless I want to make pulled chicken, at which point the skin is useless to me anyway. I prefer to make chicken in the 325f range, as it turns out much better skin at that temperature. You can even get away with cooking at a lower temperature, then cranking the heat up to finish the skin.

Finally, I would suggest ensuring that the surface of the skin is very dry, and has been salted (not heavily, just a bit), before putting it on the cooker. This, too, improves skin texture.

The TL;DR version:

  1. Quit messing with it while it's cooking.
  2. Turn the heat up.
  3. Dry and salt the skin before cooking.
share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.