Does placing a metal spoon in an open bottles of bubbles, sparkling wine & Champagne help keep its fizz ? If so why is this ?

  • 2
    Related: skeptics.stackexchange.com/questions/4636/…
    – Kogitsune
    Jun 15, 2012 at 10:16
  • 1
    Didn't Mythbusters do an episode about this?
    – Marti
    Jun 15, 2012 at 14:32
  • if they did we have not yet seen it here in NZ Jun 15, 2012 at 18:19
  • 2
    Scottish, just get a pressure stopper. You can get rubber ones designed for soda for $3 each in the states; I expect you could even find them in NZ if you went to a large dollar store.
    – FuzzyChef
    Jun 17, 2012 at 2:39

5 Answers 5


As a beer brewer, I'm pretty concerned with fizz ;) Since the below may be a little tl;dr, the short answer to your question is, "I don't think so."

This is actually the first time I've heard of the metal spoon "trick", so I can't directly comment on that, but I'll share a little of what I know about carbonation.

Carbonation is carbon dioxide (CO2) that is dissolved in the liquid (beer, champagne, soda). The fizz is that CO2 coming out of solution and escaping into the air.

Keeping it cold helps keep the fizz, as CO2 dissolves more readily into a cold liquid. And conversely, comes out of a warm liquid more readily. Ever pour a glass of warm soda or champagne straight after opening? It'll foam over everywhere.

The only way to not lose all that CO2 is to seal the container. Even then, the CO2 will come out of solution and pressurize the headspace (space in the top of the container). That's why you get a hiss when you first open a bottle.

Again, temperature comes into play. In a warm bottle, more of the CO2 comes out of solution and pressurizes the headspace. Chill that same bottle down, and the CO2 can dissolve back into the liquid, giving you a sparkling beverage again.

Now, back to the spoon. I would think that putting a spoon in the carbonation liquid would produce nucleation points, causing the CO2 to come out of solution faster. This is why many beer glass manufacturers are coming out with laser-etched designs on the bottom of their glasses - the effervescence caused by the nucleation points helps bring out the hop aromas.

  • 1
    The spoon normally does not touch the liquid.
    – Mien
    Jun 16, 2012 at 0:03

My own experience confirms the answers from the related question from Skeptics. If you hang a spoon inside an open bottle, the fizz goes out.

However, I've been able to keep the fizz in the bottle for a couple of days by putting cling film over the top.

  • good to know for when I don't finish a soda, as using the screwcap doesn't seem to help much.
    – huzzah
    Jun 15, 2012 at 13:52
  • 2
    @HeatherWalters, I'm not so sure this will work with soda... Cling film sticks very good to glass, but not to plastic. Jun 15, 2012 at 13:59
  • 1
    @HeatherWalters, the problem with cans is that they easily condense on the outside, which is mayor problem for cling film. Give it a try and report back here :-) Jun 15, 2012 at 15:24
  • 1
    Ok I'll do that!!
    – huzzah
    Jun 15, 2012 at 15:25
  • 1
    The condensation problem can be worked around with a rubber band to hold the clingfilm. Aug 30, 2013 at 15:02

Doesn't work. The CO2 gas was dissolved in the soda liquid under pressure. Once the cap is opened the liquid is now at a lower pressure (room pressure) and the gas comes out of solution. That is, it fizzes. Putting a spoon in the bottle does nothing. Resealing the bottle would stop the loss of fizz.


Read somewhere that the spoon cools fastest therefore cools the air in the top of the container. This then creates a 'cold plug' and reduces the amount of fizz that is lost.

  • 1
    Not sure this makes sense - the spoon is in contact with the liquid in the bottle, so it's going to be helping exchange heat between the air near the top and the liquid near the top of the bottle. That means the air will be warmer than it would be otherwise, not colder. (It does mean that the liquid at the top of the bottle will be cooler than it would be otherwise - maybe that's what you meant?)
    – Cascabel
    Feb 6, 2014 at 19:50
  • 1
    In any case, since this is about keeping fizz over a day or two, and by that time the temperature should've long since reached equilibrium (since the champagne would've been chilled to begin with), for it to really have an effect it has to be something besides temperature.
    – Cascabel
    Feb 6, 2014 at 19:52

It works to me, & I've been doing it continuously for more than 30 yrs- since a friend show me the trick -to keep the fizz put a spoon on top of a bottle, beer, cava, whatever sparkling it works. since ever I wonder why. and browsing out for an answer i fuond you

Still i do not know why it keeps but it does. I suspect it has to do with some geometric issue: the spoon intercepting fitzz waves coming from within the bottle. i don't know

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.