3

I made an ISI Whip recipe for Bell Pepper Mousse, chilled the mixture in the container for 2 hours, then charged the mixture twice, heard gas release, shook it vigorously 20 times and it would not discharge. On opening the canister, the mousse was not aerated at all. What happened?

7
  • "Heard gas release" as in... the gas you were trying to pressurize it with just escaped back out?
    – Cascabel
    Jul 22, 2014 at 3:58
  • 1
    Have you successfully used the dispenser before? Just in case you're unclear about how to use it, here's a (rather lame, but short and educational) video.
    – Jolenealaska
    Jul 22, 2014 at 5:35
  • to Jefromi - sounded like gas releasing inside the container.
    – user26078
    Jul 23, 2014 at 0:52
  • 2
    Can you clarify the sequence of events? I read "it would not discharge. On opening the canister" as implying that you opened it while it was fully pressurised, presumably creating a lot of mess and risking injury. Is this correct? Jul 23, 2014 at 11:02
  • 2
    sounds like you could have a bad gasket/poor seal. if you can open the canister without discharging the gas, there's no gas in there to begin with.
    – buttlord
    Jul 24, 2014 at 1:40

1 Answer 1

1

You would not have been able to open a fully charged ISI without some effort and a big mess, so I am going to assume that the gas never entered...or entered and released as you were shaking. Disassemble and fully clean your ISI...use the small brush that came with it to clean the nozzle. Check to see that all gaskets are present, particularly the large one that sits inside the top. Reassemble. Fill 3/4 with water (so as not to waste any useful ingredients), charge with one canister. Hold an cup over the nozzle (so you don't spay water everywhere) and pull the release handle to see if gas/liquid is discharged.

My hunch is that you are either missing gasket...or something is caught in the mechanism that didn't allow the valve to seal properly. You don't need much for the latter...black pepper or even raspberry "seeds" will hold the mechanism open enough for gas to escape. Since you say it was your first use, I would guess the former.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy