I have been trying to make bread using a bread mix and my mixer. I read that the amount of water you should add can vary on the humidity at the time. The mix instructions say that I should add 300ml of water to the mix but I find that by the time I have added 250ml it is already quite wet, so I never add the full 300ml. There are no instructions on how long to knead the bread if using a mixer but a recipe for bread in my mixer book suggests around 5 minutes. I have done this but I think that maybe it needs longer.

My question is: Could my bread be too dense and moist due to:

Too much water? Not enough kneading? Not leaving it to prove for long enough?

What is a "warm place"? How warm is warm, without killing off the yeast? As you can see, I'm quite a beginner with baking!

  • 1
    Can you clarify a couple things. Do I understand that you kneaded your bread using a machine? With a dough hook? And do you have the box that the mix came in? If so, what was the weight of the contents of the box (to give at least some guidance for responding to the 300ml water addition question)? And was the water you added cold, warm, or hot? Commented Dec 1, 2014 at 12:31
  • Completing first comment, regarding the warm place question, look for a sunlit space on your kitchen counter/table, otherwise, if you're using an electrical oven : turn your oven on at very low temperature (±200 fahrenheit) , leave the oven door open and sit the bread on the opened oven door. If you're using a gaz oven you can sit the bread right on the stovetop, the gaz flame pilot will generate enough warmth for the bread to rise.
    – maximegir
    Commented Dec 10, 2014 at 6:44

3 Answers 3


I was watching a Lorraine Pascale (British baker / chef) episode on TV before. She had a saying which was "when it comes to dough, the wetter the better". Don't get tempted to add more flour if your dough feels wet. She also used a mixer with a dough hook AND allowed the machine to knead it for 5 minutes.

After kneading, gently shape the dough into a rough ball shape and with a floured finger press into the dough. If it's ready, the depression in the dough should spring back so you can't see where you pressed in.


I make bread a couple of times a week and usually have light fluffy results. On occasion though, I end up with dense and fairly wet loaf. This usually happens if I have been lax and not made it in a while and haven't bought new flour/yeast. It's important to keep (dried active/instant) yeast in particular in a sealed container and observe best before dates, else it will not work as well as it should. Make sure your bread mix is fresh and well before the best before on the packet.

It's difficult to describe the consistency of a well kneaded dough - there's really no substitute for finding someone to walk you through it so you can literally get a feel for the texture of dough that is ready. If you have any friends or family that bake their own bread to results that you are aiming for, especially if they use the same mix as you, ask them if they can show you how they do it and get your hands stuck in.

For a warm place in winter I usually set my bread for proving in a bowl by a radiator in my living room.


If the bread is not wet enough, the yeast don't activate. Follow the advice that Jonny gives above. If the bread still isn't rising properly, it is either too dry or the yeast might just be too old. Check the expiration date of your boxed bread mix, and follow the directions closely. Don't start experimenting UNTIL you have had success otherwise your own adjustments might be causing the problems you are having.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.