I've been trying to work on nice bread but am having issues with the bread not rising in the oven. The first rise after kneading seems to go well, as does a short rise after shaping but before going in the oven.

At this point I've experimented with longer/shorter times for everything and am at wit's end. The bread tastes fine and has some good bubbles in it. It's just very flat.

  • What temperature are you baking at? Are you slashing the loaves?
    – Joe
    Commented Oct 1, 2010 at 20:45

2 Answers 2


Oven spring is caused by the air pockets in the dough expanding from the heat. (Dough rises from gasses released from the yeast.)

After the shaping and final rise, often times there is a light, dry "skin" over the dough. By slashing a dough before it goes into the oven, you break this skin, and the bread is able to expand. If the loaf is a "fancy loaf" and you can't slash it without ruining the appearance (like a braided loaf), try to keep the loaf from drying out with a light mist of cooking spray after shaping and before the final rise.

Perhaps the bread is cooking too quickly when it hits the heat of the oven, essentially cooking a crust before the air pockets get heated enough to expand? Baking in a moist environment should help with that. Place an empty, sturdy pan (I use a cast iron skillet) on the bottom rack of the oven (or directly on the floor of the oven) before preheating. When you place the bread in the oven, pour about 1 cup of very hot water into the empty pan. This will create a bunch of steam, and help prevent the bread from crusting before it gets its "spring."

If you have a pizza/baking stone, use it. Having a hot surface to set your pans on helps with the rise. Think about it... you open the oven door, and out goes a lot of the heat... even though the walls of the oven are retaining the heat, it will take a little while before that heat reaches the bread. Setting the pan on the stone will give you that instant heat on the bottom, causing dough to rise from the bottom up, rather than just getting a small rise from the top area.

If you don't have a stone, invert a heavy baking sheet, cast iron griddle, or something similar, and heat that up in the oven the same as you would for a baking stone. Invert the sheet pan so it's easier to slide your bread pans on and off the hot pan without having to deal with a small edge.

If you haven't got equipment to do the other options listed above, you can try the "cold oven method." Just put the loaf into a cold oven, and set the temperature. Don't preheat. The gradual heat from the bottom of the oven as it preheats will give you some of that "oven spring."

I use a baking stone and steam, but I have had great success with using an inverted aluminum sheet pan with steam before I got the stone... and before I learned that trick, I used the simple cold oven method (no steam as the oven is cold!).


When you say your first rise goes well, you mean it at least doubles in size? You should be able to easily punch the dough down and have it give off a big burst of gas and not spring back. If so, clearly your yeast is alive. If that is the case, I think your most likely problems are too short a final rise after shaping the dough, or incorrect oven temperature. Use an oven thermometer to check that.

The amount that the loaf grows in the oven is called oven spring. There are some other causes as well, see this thread at egullet for other ideas: http://forums.egullet.org/index.php?/topic/120919-oven-spring/

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.